If someone can help
I have a dead (Bad Bios Flash) ms 6367 nForce chip mother board which has a 3.3v Plcc bios chip and a ms 6570E nForce2 chip mother board which also has a 3.3v Plcc bios chip (Working).
When I Hot Swop and I use uniflash I get #152 and it will not read the bios image from the floppy drive but uniflash sees the chip (winbond W49V002AP)
I have tried 2 drives and 3 floppys same thing.
Has anyone that has mentioned this in past threads got around the problem
Hot swop
IIRC, Uniflash has problems with the NForce2 chipset...
http://www.uniflash.org/hardware.htm
http://www.uniflash.org/hardware.htm
Thanks ajzchips for the repley.
I do no that there is a problem with uniflash and some Nforce2 chip sets, I was just wondering if anyone had got around this with another software.I have tried using winflash which does communicate with the chip, but the flash file for the MS-6570E is 512k and is only 256k for the MS-6367 and it will not load the 256k file but will load the right 512k file for that board and have tried dubling the 256k file to make a 512k file but winfash would not accept it.
Thanks anyway m8
I do no that there is a problem with uniflash and some Nforce2 chip sets, I was just wondering if anyone had got around this with another software.I have tried using winflash which does communicate with the chip, but the flash file for the MS-6570E is 512k and is only 256k for the MS-6367 and it will not load the 256k file but will load the right 512k file for that board and have tried dubling the 256k file to make a 512k file but winfash would not accept it.
Thanks anyway m8
