i flashed a a7v266 mb with the latest bios flash
from asus. the flash went through and it said it was successful.
(yes it said it!)
but after power off/on no video with
1 long beep
and 2 short ones,
then it seeking floppy drive.
(it does this with or without video card in agp slot.
this video card does work and i used it while i was flashing it.)
i can load dos boot disk and it loads it, i can type in stuff
and it will read the disk.
i have tried reflashing it with typing in uniflash -e oldbios.bin
but no go, uniflash wont flash it.
it runs, it reads bios image, then when flashing continous beeps
indicating error.
i can hit Y on keyboard to retry and N to cancel.
i have even used the -FORCE option with the SST flash chip
model 49LF020. still uniflash doesnt work.
asus aflash.exe seems to hang after you run it so i cant step through
that either. any other programs out there that will force flash this?
i believe its award bios and have tried the awdflash.exe as well with no
luck.
im hoping i can revive it since i can load dos boot disk and system appears to respond in that sense.
asus a7v266 successful flash but now no video, floppy ok
-
- BIOS Guru
- Posts: 3153
- Joined: Thu Mar 21, 2002 8:16 pm
- Location: Near Hannover (CEBIT) Germany
- Contact:
Does this Board have jumperfree mode and jumper mode for CPU settings ?
Try to configure the CPU per jumper .
Clear CMOS .
What flashtool was used ? > Winflash or Aflash or Bios integrated flash tool ?
Do you have an old PCI VGA card laying around ?
Do you have a retaiol A7V266 or some type of OEM-version from HP or similar system builders or a subrevision e.G. A7V266-E ?
Try to configure the CPU per jumper .
Clear CMOS .
What flashtool was used ? > Winflash or Aflash or Bios integrated flash tool ?
Do you have an old PCI VGA card laying around ?
Do you have a retaiol A7V266 or some type of OEM-version from HP or similar system builders or a subrevision e.G. A7V266-E ?