(the 5pins header is onthe motherboardboard)
i nthe net i ve found some info for pcpartners mobos
pin#1 +5V
pin#2 No connection
pin#3 Mouse Data
pin#4 Ground
pin#5 Mouse clock
bu i want to doubleecheck/verify/confirm
before i make the cable .
Anyone confirming ???
thanks in andvance.
PS/2 pinout header in an epox lxrmobo
I realize this thread is a git old, BUT to provide the best info we are going to need MORE info......
Please provide a detailed desription of the motherboard you are looking for this info on.
Toby
Please provide a detailed desription of the motherboard you are looking for this info on.
Toby
Compaq-Fu Master
-
- New visitors - please read the rules.
- Posts: 11
- Joined: Sat Nov 23, 2002 4:57 pm
- Location: ThessalonikiMacedoniaGr
the motherboard is an epox ep-68lxr (lx chipset)
the reply is fast enough (In greece we say -better late(r) than never-).
is there a possibility to find
with a polymeter to find the pinout ????
[
"I realize this thread is a bit old,"
the reply is fast enough (In greece we say -better late(r) than never-).
is there a possibility to find
with a polymeter to find the pinout ????
With ohmmeter, you can find which of the pins is GND and which one is +5V. Test resistance between the GND pin and ground somewhere - e.g. the metal case - it should be near zero. To check the +5V, test resistance between the +5V pin and the +5V pin of the power supply connector (see http://www.hardwarebook.net for pinouts).
You can then try which of the other pins are mouse clock and mouse data - you will not damage anything if these are not connected properly.
You can then try which of the other pins are mouse clock and mouse data - you will not damage anything if these are not connected properly.
Patched and tested BIOSes are at http://wims.rainbow-software.org
UniFlash - Flash anything anywhere
UniFlash - Flash anything anywhere